Stainless Steel Bracket for BioSteps
The Stainless Steel Bracket is an optional brace. It can be installed across the top of the BioSteps 10 filter in order prevent bowing of the filter tank walls. This helps hold the walls tighter so the media is a snug fit. This will help prevent channeling of water around the media. It is especially useful in warm climates where the filter is in a hot area and the walls may be bowing. Always be sure to keep your lid on tight because this will help to maintain the proper shape of the filter tank and prevent bowing.
Item #
Description
Dealer
SB
Stainless Steel Bracket for BioSteps 10
More BioSteps 10 Filter Parts ↓
The Inlet Fitting at the top of filter is a clear threaded connector with an O-ring and a black nut. The clear fitting is a unique fitting. It has male threads on the outside and female threads on the inside. The easiest way to connect the inlet fitting is as follows:
Place O-ring over...
The Outlet Fitting is located in the filter at the opposite end of Inlet Fitting. It includes the nut, an O-ring and the outlet connector. Always install the O-ring on the inside of the filter tank. The outlet connector has two internal pipe sizes. PUt your finger inside the outlet connector and...
The Drain / Waste Fitting is located on the bottom of filter tank. It includes a barb with threaded plug , 2 O-rings and a nut. Use one O-ring on each side of the filter tank. The plug end is a 1" sch 40 PVC female thread. You can install a 1" PVC male adapter with wrapping tape and then glue on...
Easy to replace your old media with our pre-cut sheets ready for drop into the BioSteps.
Available in green density, blue density, gray density.
Old style BioSteps used a piece of soft open cell foam as the last section in the BioSteps. This has been replaced with another piece of gray Matala...