BioSteps 10 Outlet Fitting
The Outlet Fitting is located in the filter at the opposite end of Inlet Fitting. It includes the nut, an O-ring and the outlet connector. Always install the O-ring on the inside of the filter tank. The outlet connector has two internal pipe sizes. PUt your finger inside the outlet connector and you will feel both sizes. The first pipe size is a European fit. The next pipe size is U.S. PVC SCH 40 1.5". Insert 1.5" sch 40 PVC pipe all the way into the outlet connector until it stops and then push and twist real hard and it will lock in. This is a compression fit so you do not need glue.
Item #
Description
Dealer
OUTFIT
BioSteps 10 Outlet Fitting includes O-ring
More BioSteps 10 Filter Parts ↓
The Inlet Fitting at the top of filter is a clear threaded connector with an O-ring and a black nut. The clear fitting is a unique fitting. It has male threads on the outside and female threads on the inside. The easiest way to connect the inlet fitting is as follows:
Place O-ring over...
The Drain / Waste Fitting is located on the bottom of filter tank. It includes a barb with threaded plug , 2 O-rings and a nut. Use one O-ring on each side of the filter tank. The plug end is a 1" sch 40 PVC female thread. You can install a 1" PVC male adapter with wrapping tape and then glue on...
Easy to replace your old media with our pre-cut sheets ready for drop into the BioSteps.
Available in green density, blue density, gray density.
Old style BioSteps used a piece of soft open cell foam as the last section in the BioSteps. This has been replaced with another piece of gray Matala...
The Stainless Steel Bracket is an optional brace. It can be installed across the top of the BioSteps 10 filter in order prevent bowing of the filter tank walls. This helps hold the walls tighter so the media is a snug fit. This will help prevent channeling of water around the media. It is...