BioSteps Inlet Fitting
The Inlet Fitting at the top of filter is a clear threaded connector with an O-ring and a black nut. The clear fitting is a unique fitting. It has male threads on the outside and female threads on the inside. The easiest way to connect the inlet fitting is as follows:
- Place O-ring over the barb end first and slide it over the threads until it stops.
- Insert the barb end from the inside of the filter tank and push through to the outside of tank. The O-ring should be touching the inside wall of filter tank.
- Slide the black nut over the barb end (from the outside of tank) and tighten down the threads until fitting is secure.
- If you are also attaching a UV Clarifier to inside of BioSteps you must loosen the inlet fitting a little so it can spin. Position the UV Clarifier inside the tank and align the male threads of UV with the female threads of the inlet fitting. Twist the barb fitting to secure the UV as tight as it will go by hand. Do not use tools.
Item #
Description
Dealer
HOSECLR4
BioSteps Inlet Fitting includes O-ring
More BioSteps 10 Filter Parts ↓
The Outlet Fitting is located in the filter at the opposite end of Inlet Fitting. It includes the nut, an O-ring and the outlet connector. Always install the O-ring on the inside of the filter tank. The outlet connector has two internal pipe sizes. PUt your finger inside the outlet connector and...
The Drain / Waste Fitting is located on the bottom of filter tank. It includes a barb with threaded plug , 2 O-rings and a nut. Use one O-ring on each side of the filter tank. The plug end is a 1" sch 40 PVC female thread. You can install a 1" PVC male adapter with wrapping tape and then glue on...
Easy to replace your old media with our pre-cut sheets ready for drop into the BioSteps.
Available in green density, blue density, gray density.
Old style BioSteps used a piece of soft open cell foam as the last section in the BioSteps. This has been replaced with another piece of gray Matala...
The Stainless Steel Bracket is an optional brace. It can be installed across the top of the BioSteps 10 filter in order prevent bowing of the filter tank walls. This helps hold the walls tighter so the media is a snug fit. This will help prevent channeling of water around the media. It is...
